Configurator

This section documents the WingFlight Configurator tab by tab, in the order they appear once connected to a flight controller.

The Configurator's tab list adapts to your connection state and firmware capabilities -- some tabs (like ESC Programming or GPS) only appear if the relevant feature is enabled or detected.

Tab	Purpose
Status	Live connection/system status
Setup	3D orientation preview, sensor status
Configuration	Board alignment, receiver mode, ESC/motor protocol, system-level settings
Power	Battery/voltage/current monitoring
Receiver	RX protocol and channel mapping
Failsafe	Failsafe stage configuration
Mixer	Airframe/control-surface mixing
Servos	Per-servo output configuration
Motors	Motor output testing and configuration
Curves	Throttle and control curves
Profiles	PID tuning profiles
Rates	Stick response/rate profiles
Gyro	Gyro filtering
Auxiliary (Modes)	Flight-mode-to-switch mapping
Adjustments	In-flight tuning via transmitter switches
Logic Conditions	Custom in-flight logic
GPS	GPS setup and rescue
LED Strip	Addressable LED configuration
Beepers	Audible alert configuration
Sensors	Raw sensor data
ESC Programming	Passthrough ESC configuration
Blackbox	Flight-data logging
CLI	Direct command-line access